How To Replace Your Whirlpool Refrigerator Water Filter
Easy Guide to Replacement Water Filter Installation in Whirlpool Refrigerator
Refrigerator water filters are one of the most important parts of your appliance. But why don't you know how to change it? You should use the same orientation of the filter which was previously installed as it will make the process of cleaning easier and more effective. In this article, we're going to look at how to change your water filter in a whirlpool refrigerator.
Step-by-step instructions
-
Locate your water filter cover in the upper right-hand corner inside your refrigerator or in the base grille.
-
Lift the filter door up.
-
Pull the filter out and discard it.
-
Open your new filter and remove the protective coverings from the O-rings. Make sure the O-rings are still in place after the cover has been removed.
-
When inserting the new filter into the slot, make sure the arrow is pointing upward. Do not force the water filter. If it does not slide in easily, rotate it until the notches are properly aligned with the grooves.
-
Push the filter door closed so it snaps into place.
-
Once your filter is replaced, run four gallons of water through the line to properly flush the new filter.
