How Do I Change The Filter In My Whirlpool Ice And Water Refrigerator?

The way your water filter takes care of you, shouldn't you take care of it in the same way? Since it provides clean and safe drinking water, you should repay its efforts by retiring it on time. Refrain from unnecessarily delaying replacing the water filter in your Whirlpool ice and water refrigerator. You can do it independently by following the steps mentioned in this blog.
Step 1 - Go and Buy the Water Filter
Though it may seem obvious, it still needs to be mentioned that run to the store or order a new high-quality water filter online. You may buy online from a trusted supplier like WaterFilo Water Filters, where you get certified products. Also, check the compatibility of the water filter with your refrigerator to ensure proper functionality. Once you get the correct replacement, move ahead with the next steps.
Step 2 - Find the Location of Your Water Filter
Open your refrigerator and locate your water filter. The placement of the filter depends upon the model of Whirlpool refrigerator you have in your kitchen. You may find it in the grille at the bottom of your refrigerator or in the interior of the refrigerator cup, which is usually on the rear right-hand side corner. Grab the usual manual to determine its location if you struggle to find it.
Step 3 - Prep the Floor and refrigerator
Before you start working, if the filter is on the outside, place a towel under the refrigerator to avoid spilling water. However, if the filter is on the inside, put the towel underneath the filter because the water is sure to spill down.
Furthermore, begin after you empty your refrigerator. We suggest you remove every edible and other item from the fridge so that you can replace the water filter conveniently and safely.
Here are a few more things you need to be careful about:
- Turn off Ice Maker - If your Whirlpool refrigerator's ice maker is on, turn it off while replacing the weather filter.
- Turn off Water Supply - Many new models of Whirlpool automatically turn off the water supply when you remove the water filter. But if you have an older model, consider turning it off manually.
Step 4 - Take Out The Old Filter
If Filter is In the Grille - For the filter in the grille, you have to press the button on the left of the filter to remove it; then, you can pull it out. However, if there is no button, you need to turn it counterclockwise, and it will release it so you can take it out. Also, remember that you may have to push it while turning to remove it.
Filter Inside The Refrigerator - If the filter in your whirlpool refrigerator is on the inside, you first consider removing the cover, or you might need to push it up in your model. After removing the cover, push the button on it and take it out, or in case there's no button, then push the filter and start turning it in a counterclockwise direction until it gets loose enough to remove it.
Step 5 - Insert the New Filter
Depending upon your Whirlpool refrigerator model, you either have to insert, push and turn it clockwise until it fits or if it has a button, you need to click on it to place your water filter.
Important Note: When you finish installing, make sure the filter is placed precisely in the location of the old filter. Double-check is advised to confirm the filter location and avoid water leaks.
Step 6 - Flush Out The Water
To get rid of the old, contaminated water in your refrigerator, you must clean it out. Whirlpool instructs that after installing a new filter, you should drain around 4 liters of water before drinking it.